NMEA Router

NMEA Router is a software that forwards an NMEA stream from one or several AIS receivers. It is useful for AIS partners with several receivers. Read more about NMEA router here: http://arundale.com/docs/ais/nmearouter.html

Requirements:

• It is possible to connect the receiver to a computer (USB, serial or network).
• The connection method is known (COM port, IP, etc.).
• The computer runs on Windows and is working non-stop.

Configuration:

	Download the software from here: http://arundale.com/docs/ais/ais_decoder_v3_downloads.html After installation start the application and set up a new profile: Configure → Profile → New
	Label the profile with a name of your choice and click OK.
	Set up a new source (AIS receiver):  Configure → Connection → New
	Label the source (connection) with a name of your choice. Choose Serial as Type of Connection if the AIS receiver is serial or connected via USB. Click OK to continue. The Serial Port Configuration window will appear.
	Choose the COM port your receiver is connected to under Device and the Baud Rate to 38400. Select Input as Data Direction. Click OK to continue.
	Set up a new data receiver:  Configure → Connection → New
	Label the data receiver, i.e. with "FleetMon". Select UDP/TCP as Type of Connection. Click OK to continue. You will get to the UDP/TCP configuration window.
	As Protocol can be selected UDP or TCP. As Data Direction select Output. Configure the Remote Host. An own port for statistics and the upgrade to the Unlimited account can be ordered here: https://www.fleetmon.com/my/ais-stations → Add my AIS station Until this has been confirmed via email, data can be sent to the IP (148.251.96.197 or ais.fleetmon.com) and port (34003) shown in the picture on the left side. Save with OK.
	Generate a route, so the data of the source can be sent to the receiver:  Configure → Route → New
	In the field Between select which source should send to which receiver in the field And. Make sure to tick the box Enabled. Save with Ok.
	If the connection does not start automatically, you have to start it manually: Click on the Start button. Now you can see how the data is being transferred. Add NMEA Router to Startup in Windows System Configuration, so you don't have to start the program manually each time. You are finished! Go now to FleetMon.com and check your "My AIS Stations" page. After 5-10 minutes the statistics of your data should be displayed.